PCB Design

$30-250 AUD

クローズ

投稿日:

5年以上前

$30-250 AUD

完了時にお支払い

Hi All, I'm looking to work with someone to design a PCB board for a GPS Module and suggest potential components. The module will be battery powered ( Not LiPo), need to have low power consumption, be able to run some code (max memory approx 20,000 bytes). It will work with a Tri-Band LTE-FDD and Dual-Band GPRS/EDGE module solution, most likely the 7000 series. The outcome for this project will be: One page of potential components with possible suppliers with pros / cons of each component PCB Design and revisions (This can be capped if necessary). I look forward to viewing your proposals. Regards, Trent and Natha

Circuit Design

Electrical Engineering

Electronics

PCB Layout

Product Design

プロジェクト ID: 18000748

プロジェクトについて

5個の提案

リモートプロジェクト

アクティブ 5年前

お金を稼ぎたいですか？

メールアドレス

Freelancerで入札する利点

予算と期間を設定してください

仕事で報酬を得る

提案をご説明ください

登録して仕事に入札するのは無料です

この仕事に5人のフリーランサーが、平均$193 AUDで入札しています

@Euroaccount

Hello How are you? I am an expert in PCB design with more than 7 years of experience and I have rich experience in developing GPS tracking device and PCB design. So I am sure that your project is the best match for my skills and experience and I will give you the best result . Thanks.

$155 AUD 3日以内

4.9

(26 レビュー)

7.3

@KartikSheladiya

Hello there, Greetings!!!! I am from Ahmedabad, Gujrat and I have already developed GPS device and can share you PCB design and BOM for the same, also I can send you a sample(at minimal cost) if you want. Do visit my portfolio to see the design Regards, Kartik Sheladiya

$500 AUD 3日以内