Develop an oscilloscope using FPGA kit ZC706 and FMCJESDADC1 card

$250-750 USD

キャンセル

投稿日:

6年以上前

$250-750 USD

完了時にお支払い

I am looking for FPGA guys who have done work on FMCJESDADC1 card, ZC706, RAM Controller, Petalinux. Please do not bid if you have not done work on this hardware. Anyone who is participating on bidding, please show me the examples of work you have done on this in past. 1. Take data from FMCJESDADC1 card using JESD204B (already implemented) 2. Perform analysis (FFT, etc) 3. Save Data in PL RAM 4. PS gets the data and send it to remote PC over TCP/IP. 5. PS has Petalinux installed 6. Use FPGA Drive (from Opsero) to save the data permanently.

Electrical Engineering

Electronics

FPGA

Verilog / VHDL

プロジェクト ID: 16153219

プロジェクトについて

5個の提案

リモートプロジェクト

アクティブ 6年前

お金を稼ぎたいですか？

メールアドレス

Freelancerで入札する利点

予算と期間を設定してください

仕事で報酬を得る

提案をご説明ください

登録して仕事に入札するのは無料です

この仕事に5人のフリーランサーが、平均$1,802 USDで入札しています

@ahmedmohamed85

Dear sir I have implemented Spectrum Analyzer using ZedBoard, also i have done the same using ML605 board and 4DSP data acquisition card, i have more than 10 years experience in digital design using FPGA

$1,500 USD 10日以内

4.9

(419 レビュー)

7.8

@eopskzs

I have previously worked with different families of Xilinx products and development platforms, including the zedBoard and ZC702 from Xilinx with high-speed video interfaces. I haven't used this specific board and FMC add-on hardware but they are pretty similar with what I have worked with. Please, feel free to contact over chat if you have any questions. Best regards,

$1,400 USD 25日以内

5.0

(6 レビュー)

4.2

@bondwp322

Hi, I am an experienced programmer and I'm sure I can complete your project asap. Please contact me and tell about your project details. I promise a high quality and punctual work. Thanks. ProjectName:Develop an oscilloscope using FPGA kit ZC706 and FMCJESDADC1 card Relevant Skills: Electrical Engineering, Electronics, FPGA, Verilog / VHDL,

$555 USD 4日以内