組み込みソフト Jobs

Design of Digital filter algorithm/ code in C for ARM processor for processing real time raw sensor to removal of noise & unwanted signal Algorithm / code for Digital Filter low bandwidth Real time Sensor Signals 1. Analogue Raw data acquisition in real time at 1000 samples per second in 24 bit precision 2. Raw data signal bandwidth /frequencies restricted to less then 1000 hz by hardware RC anti aliasing filter to avoid aliasing 3. Following Digital in sequence to be applied to raw signal . a. low pass filter 0-170 hzs ( to remove high frequency random / white noise b. High pass filter 1 hz to 400 hz (to remove low frequency dur DC signal coupling ) c. Very steep(narrow band) notch filter at 50 hz / 60 hz to remove power line interference a & b can be combined as band...

*Please include descriptions of 1-2 most relevant projects delivered. *Also as part of the offer please provide comments to the 2 questions at the end of this description Linux Raspberry UDP network and serial communication component 1. Product to be done: a basic communication component handling low-volume, ca. 20-100-byte command messages with rather relaxed performance requirements. The messages will be coming on a non-regular basis from a few clients over a Wi-Fi local network, typically say 2 clients. There is no need to confirm the messages in either way. Consequently it seems that UDP is the right protocol to be used (to be confirmed by the contractor). 2. The server should also support its part of a detection mechanism that should allow the clients to automatically detect the ad...

We seek a professional, seasoned RFID SME to help design/build an embedded RFID reader for 8xx-9xx MHz frequency range. Please specify the RFID chip for reader you intend to use & why. It must be software defined and provide active digital support for it and peripherals. Please list the features you will provide over and above typical features available in other competing products. The output power, frequency & all other parameters should be software adjustable via web server. Default factory settings set option. Review the attached sketch. Green dotted outline is out of your scope. Once interface to green part is defined, we shall have you review it as a change. We are in RFID business deeply for several years. More details (if needed) can be provided to shortlisted persons only....

I'm looking for a professional who has experience in debugging ESP32 through JTag. My circuit with ESP32 is newly pronted and not tested yet. I need to do some steps with an expert who can dive deep into the debugging process. The ideal freelancer for this job should have: - Proficiency in handling and debugging ESP32 through JTag - Familiarity with Espressif IDF development environment

I require a software solution that can extract and unlock full calibration data from a sensor for further analysis. The software must have the ability to interact with the sensor via USB connection. Key Features: - should be able to fully extract the calibration data from the sensor - the tool should be user-friendly and have a clear interface - the software should have a USB connection for the sensor - the software should be able to output the data in a readable format for further analysis Ideal Skills: - Proficiency in software development - Experience in sensor calibration and data extraction - Familiarity with USB connections and software interfacing - Strong understanding of data analysis and presentation The project will require a combination of technical and practical skills, so ...