Speed and Direction Control of 220V AC motor
$30-250 USD
着払い
I need a circuit, which can provide speed and direction control of AC motor. The power supply should be 220V. The circuit will comprise of three controllers, as shown in the attached image.
1. The first controller will control the direction of rotation:
"LEFT", "RIGHT" and "ALTERNATING LEFT AND RIGHT" directions can be chosen by using this controller. I can supply this controller switch, but its better that we avoid using this switch. Instead of this switch, I would prefer using four touch buttons, among which we can chose only one at a time. The modes for this button are as described below:
a. for OFF position
b. for left/clockwise rotation
c. for right/counter-clockwise rotation
d. for alternating left and right rotation with timing control (using button 2)
2. The second controller will control the duration of left and right rotations, when the machine is in "ALTERNATING LEFT AND RIGHT" mode. The attached image shows the duration in seconds.
3. The third controller will control the speed of motor.
I just need the circuit with these buttons. The start and stop of this circuit should be controlled by a switch/button which should be 12V.
Preferably, the project will be awarded to someone based in UAE, Dubai.
Circuit to be shipped to Dubai, UAE along with the speed and direction controllers/buttons.
The project is preferably for people in UAE.
プロジェクトID: #16624813
プロジェクトについて
17人のフリーランサーが、平均$224 で、この仕事に入札しています。
Hello, Have a nice day. We will design, prototype and test the circuit. Once it is working perfectly we will hand over the production files as well as ship the prototype PCB. We have good experience in dealing with もっと
I have long experience with 8-bit & 32-bit micro-controllers . I worked lots with HMI devices like touch screens and iButtons . I also worked with relays and switches. I deliver neat and well-commented codes , so th もっと
Hello there! Hope you doing good! If you still need this to be done, be sure to contact me. Lets make something awesome! Greetings!
Hello employer, I am confident that I can provide the required circuit design. I assure you constant revisions and support till you are satisfied with the work. Thanks in advance.
Hello. I can make the circuit and send you simulation and circuit design. for pcb and fabrication can be done from uae. I will charge the least since its an easy task for me
Hello, We have reviewed your project description and our embedded team would be enriched about to assist you. We have a team who are extremely dedicated and experience in raspberry pi, Schematic diagram, layout des もっと
How about a potentiometer for the timer and speed control? It could be set up as a resistor divider to feed an analog signal to the Arduino, which would then be converted to time and speed. You could still mark the ten もっと
Have already been working with power supply designs, which consists of AC voltage handling. Have rich experience in Motor Controller Design.
