Make PCB Etched 700 Mhz Antenna
$250-750 USD
着払い
We are evaluating antenna options for a small RF device. This project is to etch and place a 50 ohm impedance 700 Mhz center frequency antenna on a surface area limited to 14 mm x 9 mm. Outside that 14 x 9 mm surface area, say in the 10 mm adjacent to the actual etched antenna, we want a standard [login to view URL] male connector to interface with RF test equipment. You can pick the PCB materials, etched line thickness, plating metal, etc. in order to optimize performance. We want 3 pieces of this small antenna. Boards will be shipped to US location.
プロジェクトID: #17832574
プロジェクトについて
アワード：
Dear Sir, I am an highly skilled board designer who has over 17 years experience on complex, multi layers PCB design. I can provide you with service from schematic entry to PCB Layout.I can also provide the prototy もっと
15人のフリーランサーが、平均$596 で、この仕事に入札しています。
Hello there, I have a team of electronics engineer and they can provide you PCB design solution for this task in no time. They will have a few questions for you. Once we have answers of all queries, you can expect a もっと
Hello. There is an experience of using miniature antennas in the range of 700-900 MHz. However, you can place only a ceramic chip antenna on the area you specified. The effectiveness of its work will depend on the size もっと
Good designer and can work around to deliver timely device on time. I can have the schematics on time
Hi, I have experience with Small antennas design. This antennas have several constraint due to him small size, i can cite low gain, small bandwidth. I have knowledge on miniaturization techniques, also, some of the もっと
Hello from Shenzhen, i am from i can design and optimize it. i can do it for you. i have pcb sample making source also.
Hello, I am Ahmed, Mechatronics Engineer, and i am ready to start your project at any time you need.
Hello! I'm currently working as a Microwave/RF engineer experienced in telecommunication antenna designing. As your description above, I think it's preferable to use chip antenna instead of pcb one in this area. Mes もっと
I am working in Space Research and Technology Center as Project Scientist. I had experience of designing experimental payload for space application. I am also engaged with the development of FMCW Radar development for もっと
I realized creative and innovative projects about electronics since 2013. I have been working as an engineer,in the area´s of Electronics, Radio Frequency and Microwaves.
