Design me a Product - Bluetooth Heart Rate Monitor (+)

I am an experienced PCB designer who has over 14 years design experience on complex PCB design. I can provide you with design service from schematic entry to PCB layout. I can support your PCB fabrication also. Most of もっと

Dear Sir, I am perfect for this project with previous working experience in BLE. ATmega or such are not required, we should use SoC like TI CC2541; this will reduce BOM. Also, Coin Cell battery guarantees the ope もっと

Hello, As a plus I have design such a device that measure the impedance of the body I have a master degree in bio-medical electronics and I can assemble and test the device I can use atmega processors if you want. もっと

G'day from Australia !! I've got that extrensive experiance your looking for, 25+ years of it doing R&D for mass production in Electronics design. I have also developed quite a few Bluetooth projects. I am also q もっと

Hi, We are a team of electronics&embedded engineer with more than 10 years of experience in designing and developing various digital and embedded systems... We have done a lot of projects in Arduino/PIC/raspberry pi/ もっと

Hi. I am a professional Electronics Engineer having expertise in Electro-medical prototypes and devices. I can provide it to you. Contact me.

Hi there. My name is Keith Becker and I am a professional electrical engineer here in the US. I graduated Vanderbilt University with a BS in mechanical engineering. I now work solely as a contracting designer and freel もっと

Hello, Thanks for posting this job on Freelancer. As per your requirements we are perfect match to the skills and expertise required for this job. Some Questions we have :- Are you open to other more expens もっと

Our engineers have 8 years experiences on electronic engineering, wireless engineering, and PCB design/layout. We are very familiar with Bluetooth device. In addition, one member in our team achieved his PhD degree in もっと

Hi, I have developed this type of product before, where i had to measure heart rate variability, using finger probe to get the signal, and amplify, filtered the signal. I used a DSP as my processor.. as far もっと

ConceptFlys Technology Labs team consists of experts in all phases of embedded development such as problem study, architecture definition, analog and digital schematic design, PCB Layout of high density / high speed b もっと

Hello there, Thank you for sharing your requirements on Freelancer. Our hourly rate is $20/hr for Embedded domain. Let's get connected to discuss about the project in details. Regards, Intel IT Hub_KM

A proposal has not yet been provided

Greetings and good afternoon. My name is Greg and I work for an engineering consulting company called TALOS X. We have a large interest in developing ideas and building prototypes so this seems right up our alley. I li もっと