Arduino Code for simple Keystroke to GPIO out
£10-20 GBP
着払い
I want some simple code to run from an Arduino Uno. This must run at boot level with no OS.
I am looking to use a0-5 & 10-13 as inputs (with adjustable trigger voltage such as 5.00v on, 4.99v off) which then operates the 1-9 as outputs but in one of the configurations below;
I then want each output to be configured (easily) to do one of the following when either activated by the key or the analogue input;
1) When the input is triggered, it switches the output on and latches on, then you have to press the same key again to switch it off.
2) Hold to activate (only outputs while the matching input is triggered).
3) When a key is pressed once, I want this option to turn on then off several times (on-off-on-off-on-off....). I want the amount of times and the speed (ms) to be easily configurable with an optional longer gap between sets (eg. on/off x4 at 100ms then 1000ms gap then repeat for 3 times) this would probably need these options;
On/off number of times
Speed (ms)
Gap off before repeat (ms)
Number of repeats
プロジェクトID: #18568452
プロジェクトについて
12人のフリーランサーが、平均£32 で、この仕事に入札しています。
yes buddy,,,me here to do this,,u will feel brotherhood,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Iam Embedded Software Engineer . 4 years experience in Embedded Systems and Robotics . Experienced in Pic microcontrollers , Arduino and Raspberry pi . Participated in the EED with my autonomous rescue robot and in もっと
Hi! Seems not very complicated project. Let's discuss your needs in chat, probably I will be able to help
Hi! I am Expert in Arduino programming and their analog and digital input/output related tasks. I understand your project and will complete your task in time with full dedication. I hope to work with you!
I've done many arduino projects and I can help you with the design of this FW. I'will give you source code with many comments
Dear Sir, I have done multiple higher-level projects and I am looking forward in doing this project. Feel free to contact me.
I'm an engineering student and I have the knowledge about circuit design, microcontroller which is suitable for this job Relevant Skills and Experience I have done many Arduino projects. I know c++, Arduino IDE
