Design a PCB and program an Arduino microcontroller

hi sir i am an expert electronics engineer with almost 7 years of experience in PCB design. i have implemented a number of systems based on arduino. please share the further details of your task. i am waiting for your もっと

I CAN DO ONLY HARDWARE. Hello, I have been associated with Hardware design (Circuit / Electronics design), PCB design, Library creation and Library database maintenance, PCB Manufacturing, Component procurement, もっと

Hi, I have expertise in designing PCB using Proteus. I have read the project document and I can design a PCB according to your requirement. Looking Forward,

Hello, I am Anthony. I am working FULL TIME as freelancer. I have double degrees in Mechatronics and Applied Science fields. I have very good feedbacks on freelancer.com . Please check the lin もっと

hello dear I have experience in designing open source quad controllers such as multiwii.. I can help you..if you wish we can discuss in chat..

I am an Electrical Engineer having specialization in Electronics and Control, teaching in Electrical Department at FAST National University Pakistan. I am also persuing my MS degree in Electrical Engineering with speci もっと

Hi, I have more than 12 years of experience in embedded system design and development. Had experience in PCB design and Arduino. Please let me know if you are interested. Regards, Ratheesh

Controlling 12 9g servo is possible with a single ATMEGA328P IC but the 4 AA batteries cannot provide enough current for the servos to work under load. which programming header you prefer 6pin SPI or FTDI or USB ?

Hi friend. I am an Arduino and electronic design teacher. I have 5 years on experience about Proteus and I wait to make a good job with you. Best regards.