CAD Designer and 3D Printer Specialist for Customized Formula 1 Front Wing Art Piece - 27/03/2023 21:31 EDT

ステータス: Closed
賞金: $110
受け取ったエントリー: 12
優勝者: MaxPraym

Winner

コンテスト概要

I need to have this STL file slightly changed and then finalized to be ready for a 3D print.

Things I want to be changed:
1. Remove all of the indentions, logos, numbers etc.. on the top of the wing, it should just be flat surface.
2. Keep the same scale but the Y value should be 310mm in width. So increase the size of the whole thing.
3. No piece should be less than 2mm in thickness so it will not be weak when printing.
4. I want to add a 4th row to the wing. So looking at the current file you can see there is only 3 (well call them slats, but they are the slats that make up the wing.) I have attached photos showing most of the cars have 4 slats. Can you move them all down a little like shown in the picture and then add a smaller slat at the top.
5. Remove the hole in the front of the nose.
6. All the slats need to be connected, can you add small connectors like shown in the photos

Please see the PDF attached for more information and let me know if you have any questions.