java expert is needed

終了済み 投稿 5年前 着払い
終了済み 着払い

java expert is needed

I am working with STL files for 3D printing. normally contain the hull of a shape with no thickness. Imagine the shapes to be similar to a cup that you drink from. With this as an input, the utility should do the following: 1. Calculate the volume of the shape. 2. Extend the top of the shape an additional 4 mm (just a plain extrusion). 3. Project an additional surface 0.8 mm outwards and close the shape at the top (just flat, nothing fancy). This is to create a mold that will have 2-part rubber poured into it. 4. Using a specific density (1.06 g/mm3) of liquid filled to the initial height (before the 4 mm extension), calculate and create supports for the mold such that it can withstand a 10 degree tipping without falling over. There should be 4 supports, projected from the calculated center of gravity, 8 mm x 0.8 mm, going up from the 'floor' at 55 degrees, with very small feet around the supports. 5. A small notch (running most of the length of one side) has to created on a specific side of the mold, which brings the thickness down to approximately 0.4 mm. 6. The output file must be a valid STL file, and must run as a command-line utility on linux. 7. Java is preferred,

3Dモデリング Java ソフトウェアアーキテクチャ

プロジェクトID: #18828942

プロジェクトについて

2個の提案 リモートプロジェクト アクティブ 4年前

2人のフリーランサーが、平均$178 で、この仕事に入札しています。

atulamol

Hello, I have More than Five years (5+ years) of experience in Professional Software Development. Seeking for a challenging position as a Java Developer with the strong working experience in programming, designing もっと

$200 AUD 3日以内
(40件のレビュー)
5.0
mukesh30march

hi i read all requirement please share more detail about project i did similar task i will provide 5 star rating work thanks

$155 AUD 3日以内
(24件のレビュー)
3.9