This should be a simple job for someone who has done the Junos configuration before. It should take no more than 2 hours, please bid accordingly. There is no router configuration required in this task. Just a simple document, similar to the attached will do, just for Junos.
Please see the attached document of a Cisco configuration. I basically want it translated so I can run it on an SRX110 with 12.1X44-D40.2.
I believe that the SRX110 has 8 queues on an interface, if that is going to be a limitation with my configuration, you can choose 8 of the classes to be included, once I see the example, I will be able to work it out the changes I require.
I need an example of:
i) a LAN interface policy to mark the traffic entering the router
This is "policy-map BRANCH-LAN-EDGE-IN" in the attached document
ii) a WAN interface policy to apply a bandwidth limit to the overall interface
This is "policy-map BRANCH-WAN-EDGE" in the attached document
iIi) a sub policy that runs under the WAN interface policy to split the bandwidth into separate categories. This needs to cover the instances where the interface throughput is much lower than the interface capability. EG 20M metro ethernet service. Is this any difference for ADSL or 3G interfaces?
This can be seen as "policy-map 4M" in the attached document
I will also need the code fragment for how to attach the QoS policies to both ethernet, ADSL and 3G backup interfaces. All this needs to be is the equivalent of
service-policy output 4M
I will need the commands to verify that the qos policy has been applied and to show the relevant statistics. The equivalent of:
show policy-map int g0/1
Greetings of the day, i have read your requirements and Cisco Configuration also, as we discussed in the morning we can start the configuration. Thank you
I have more than 5 years experience with networking technologies i.e Cisco, Juniper, Alcatel, Linux I already have the juniper version of the configurations. Contact me to discuss.
hi, I have 6+ years experience works system administrator. I have good experience work with Juniper SRX 110, 210, 240 (including QoS). I happy to help you. Best regards, Ilya Kudryashov
I have worked as a Juniper TAC engineer for over a year and as a Cisco TAC engineer for 3 years. I can easily do this job. The only reason I am bidding low is to make some reputation here.