I have a PCB with a completed schematic. The components all the footprints. I have even placed the footprints on a PCB with reasonable positions. Most of the positions can and should be adjusted slightly during layout to make layout better. It's just things like switches, plugs, and LEDs that I'd rather not move since that would impact case design. The PCB has about 160 components that need to be routed. I've attached the kicad files for this board. The highest speed wires on the board are USB2 differential pair. Other than that nothing is very sensitive to noise, but I do need big power rails:
1) esp8266 pulses 300 mA
2) The RJ45 jacks plus AUX can pulse 500 mA
3) Sam3x uses 100 mA
The PCB process I want to use has minimum 6mil traces and 12 mil via. I would like to use a 2 layer PCB. If you think I should use more please justify it in your proposal.
When making your proposals if you take a look at the PCB and can note a few things that are important to consider that would help you get this project.
I am looking for someone who is good at efficiently hand routing a pcb like this. No autorouters.
hi i am expert about this field i have strong team we can do everything Relevant Skills and Experience Circuit Design, Electronics, PCB Layout Proposed Milestones $250 USD - 1