Research, simulate, test and debug an Audio Frequency Integrating using an OP-AMP

Task is to research, simulate, test and debug An audio frequency integrator, using op-amp - Research circuits that can build An audio frequency integrator. - Design the circuit. - Create a simulation of An audio frequency integrator showing input and output voltages. - Find faults in the development of the circuit . - Repair the faults while building the circuit. - Explain the use of the components in An audio frequency integrator and the cost of the specific components. - Test the electronic control system for proper operation. - Report writing include: o Introduction of the circuits with principles of operations o Circuit diagrams o Preliminary calculations which includes all the records of the design calculations o Display results in tabulated form, in the table which displays the results it should include the % of the difference between the calculated values and the measured values for each of the different items involved. o Discussion should include a justification for the solutions which were used to troubleshoot the problems o Conclusion o Output displays should show the voltage gain, distortion and frequency response for the circuit. o Manuscript data showing DC measurements including detailed drawings to scale of CRO outputs and a graph of frequency response. o Discussion of measured results compared with calculated and simulated results. Include any inconsistencies between calculated, simulated and measured results. o Data sheets, graphs and bibliography and reference websites are required within the report.