ATMEL AVR OBDII Code and schematic

I need the source code and schematic that will allow an ATMEL 8051 AVR chip to read Diagnostic codes from an ODBII system. Source code means the source that will be programmed to the 8051 AVR chip. Circuit Board refers to the board that the 8051 chip will reside on and all nessecarry power and interface connectors to drive the chip and allow for communication. A) Source code to read CAN (Controler Area Network / ISO-9141) B) Source Code to read VPW (SAE J-1850 VPW most GM vehicles) C) Source Code to read PWM (SAE J-1850 PWM Most Ford Vehicles) D) Schmetic of the circuit board for each of the above. (assuming the circuit will vary greatly for each one of the above connections) E) Upon powering up the circuit should put the car's computer into "real time Data streaming mode" then query for the miles per hour and upon receiving a response store the MPH in a variable that may be read and out put serialy. F) Coder must be available on yahoo aim or other messenger service for ease of communication between buyer and coder. Let me know if you have any questions. This is for a school design project that i do NOT have time to complete this summer. Thanks for your help. Jon Manley ## Deliverables 1) Complete and fully-functional working program(s) in executable form as well as complete source code of all work done. 2) Deliverables must be in ready-to-run condition, as follows (depending on the nature of the deliverables): a) For web sites or other server-side deliverables intended to only ever exist in one place in the Buyer's environment--Deliverables must be installed by the Seller in ready-to-run condition in the Buyer's environment. b) For all others including desktop software or software the buyer intends to distribute: A software installation package that will install the software in ready-to-run condition on the platform(s) specified in this bid request. 3) All deliverables will be considered "work made for hire" under U.S. Copyright law. Buyer will receive exclusive and complete copyrights to all work purchased. (No GPL, GNU, 3rd party components, etc. unless all copyright ramifications are explained AND AGREED TO by the buyer on the site per the coder's Seller Legal Agreement). 4) Circuit Schematic should be in a format of a readly avaible circuit schematic design program. **NOT A JPG, GIF , BMP or ETC IMAGE!** 5) If you want to accually build a prototype of the board and test it to make sure it works this would be worth a bonus. HOWEVER check with me after the first items are met. ## Platform Platform will be on a ATMEL 8051 AVR RISC CHIP with ALL REQUIRED CIRCUTS ON ONE BOARD.