BeagleBone Black to Control GPIO via Ethernet Commands

$10-50 USD

完了済み

投稿日:

7年近く前

$10-50 USD

完了時にお支払い

Host computer to sent Ethernet commands to beaglebone to enable GPIO. There should be 10 commands, one for each GPIO. and the command will also have the programmable amount of time to enable the GPIO. The GPIO should always be LOW until a command is received, then drive the GPIO High. All GPIO will be mutually exclusive. Beaglebone must be running Ubuntu.

Embedded Software

Linux

Ubuntu

プロジェクト ID: 14449516

プロジェクトについて

5個の提案

リモートプロジェクト

アクティブ 7年前

お金を稼ぎたいですか？

メールアドレス

Freelancerで入札する利点

予算と期間を設定してください

仕事で報酬を得る

提案をご説明ください

登録して仕事に入札するのは無料です

アワード者:

@linuxpro139

i have a BBB here and familiar to socket and gpio sysfs control on linux Relevant Skills and Experience Embedded Linux programming with C and sysfs controlling Proposed Milestones $35 USD - Control GPIOs through ethernet packets What is gpios you want to control on BBB? (for example, GPIO1, GPIO2, etc)

$35 USD 1日以内

5.0

(5 レビュー)

2.8

この仕事に5人のフリーランサーが、平均$229 USDで入札しています

@kose2joab

Hello, I think I can work on your project, but you need come clear of exactly you need to be done? Relevant Skills and Experience Python, Linux, Raspberry Pi GPIO, Networking Proposed Milestones $35 USD - Whole project

$35 USD 1日以内

5.0

(9 レビュー)

3.6

@Krunal98

Greetings! My name is Krunal. I'm an IT engineer. I would like to work on this project. I have recently worked on beaglebone project. Perhaps I could help you. Invite me in chat for more discussion. Looking forward to your reply. Cheers, Krunal

$40 USD 1日以内