I need someone to edit the attached logo in CorelDraw.
The "N" should be similar to the "X" in the upper logo, italic and the right vertical bar of the N pulled out upwards and rounded to the top while the left vertical bar of the N should be pulled down and ends in a sharp tip.
You can replace the font by something own or modify the normal Arial Bold or Helvetica bold; the current font is only for illustration what I want.
Also the kerning in the logo should be adjusted and the frame on the left hand side should be an outline contour (similar to the upper logo) ready to cut on a vinyl plotter (right now it is just a single line with a defined thickness and a white outline around the N).
At the end the lower logo should be similar to the upper logo so that the customer can see its the same source.
Guess for a good designer it's only a couple minutes, so dont quote if you ask more then 20 USD!
Final design should be delivered in CorelDraw X3 format.
Hi there, We have gone through your requirement. We are sure we can fulfil it with out capabilities 100%.. Kindly message us for further discussion Cheers Thanks, Prawin