design a 555 timer pcb board

$10-30 USD

完了済み

投稿日:

8年近く前

$10-30 USD

完了時にお支払い

need a 555 timer square wave generator: Here is the BOM for the 555 timer board. The output from the 555 will be .9mS High and .1mS LOW which will control a P-Channel MOSFET Gate through a 1K resistor. This timing can be accomplished using values of Ra = 115K, Rb = 15K, and C = .1uF The MOSFET should be mounted near the edge of the board with a wire pad for the 12V feeding the Source of the MOSFET. The etch should be cable of carrying 2 Amps. The Drain of the MOSFET should also have a wire pad which will be connect to the output of the supply. The higher current for the Ground will be external and not connected through the board. A wire pad will also be needed for Ground. The 555 will also be powered from the same 12V input connected to the MOSFET. The 100uF capacitor will be on the 12V supply input and to Ground on the board. board should be double sided

Circuit Design

Electronics

PCB Layout

プロジェクト ID: 10276053

プロジェクトについて

2個の提案

リモートプロジェクト

アクティブ 8年前

お金を稼ぎたいですか？

メールアドレス

Freelancerで入札する利点

予算と期間を設定してください

仕事で報酬を得る

提案をご説明ください

登録して仕事に入札するのは無料です

アワード者:

@chetanmandani

hello friend, i can give you a perfect solution whichever you want. I will give you a schematic in which whatever mode of 555 you want, i will made it. Also, i will care of all kind of protection like EMI, spike and proper ground. Layer of PCB will be decide as per your requirement. So, allow me to do your job.

$25 USD 2日以内