Printed Circuit Board (PCB) design and layout is the standard form of communication of design in electrical engineering, where the board and electronic components are designed onto a fiberglass type board in a Gerber File. The Gerber format is an open ASCII vector format for 2D binary images and it is the de facto standard used by PCB industry software.

Electrical Design Engineersを採用する

絞り込む

私の最近の検索
次の条件で絞り込む:
予算
to
to
to
種類
スキル
言語
    ジョブステータス
    8 仕事が見つかりました。次の価格: USD

    I have a prototype of a heated massage tool. Right now its running on a vape battery. Takes about a couple hours to charge. Then when turned on it stays hot all day, oscillating from around 130-115 degrees. I am needing a high low switch put in. Maybe adding another battery to get the lower temp up. Im working with a mechanical engineer so just need someone to work with him on the electrical part....

    $1184 (Avg Bid)
    地方
    $1184 平均入札額
    4 入札

    PCB 1: to manage external input; HDMI, twice USB Type A 3.0, SD slot and twice USB type C. PCB 2 : to manage a powerbank, better if there is the chance to implement directly the power bank on the PCB. Each board will be installed in an enclosure, all the PCBs are powered by a single power bank in order to provide serially charge to all the PCB. The power bank will also provide battery to external ...

    $50 (Avg Bid)
    $50 平均入札額
    3 入札

    Nous avons un projet afin de realiser une carte électronique, nous avons réalisé les schémas. Nous souhaitons une vérification des ces schémas et le design du pcb.

    $165 (Avg Bid)
    $165 平均入札額
    9 入札
    $35 / hr 平均入札額
    11 入札

    I need you to design a programable NMEA buffer PCB. It should be in 122mm x 110mm. PCB should receive RS-422 data and convert it to CMOS using transistors and opto couples and receivers. Outputs RS-422 data to multiple device. All input, output and power ports should be galvanic isolated from each other. Electrical connections should be according to NMEA standards(check "NMEA-0183 Information...

    $457 (Avg Bid)
    $457 平均入札額
    12 入札

    I need Led uv light intensity control using Arduino. UV is turned off and on by optical sensor t5500. UV light power is independent. The detailed task will be discussed when recruiting.

    $143 (Avg Bid)
    $143 平均入札額
    36 入札
    $5763 平均入札額
    5 入札